how to remove a garbage disposal and replace with pipes

#HOW TO REMOVE A GARBAGE DISPOSAL AND REPLACE WITH PIPES HOW TO#
#HOW TO REMOVE A GARBAGE DISPOSAL AND REPLACE WITH PIPES FREE#

The chambers, which are available from plumbers and plumbing-supply dealers, are generally installed above or near noisy fixtures.

#HOW TO REMOVE A GARBAGE DISPOSAL AND REPLACE WITH PIPES HOW TO#

If the house has well water or you are in doubt about how to drain the lines, have a plumber do it.Īnother treatment, which might be needed if draining doesn't work, is installing an air-cushion chamber in the noisy line. When draining stops, close all the faucets, retighten the union fitting, and open the water valve. All hot- and cold-water faucets in the house should be opened to let the water drain out.

In most homes, the water can be drained by closing the valve on the street side of the water meter and loosening the union fitting on the other side of the meter. It is sometimes possible to cure water hammer by draining the water out of the pipes and admitting some air. This can be fixed by locating the pipe that is banging and using a pipe strap to fasten it securly.īanging can also result when water, with no air in the pipe to ease the shock, slams into the closed valve.

You are experiencing water hammer, caused by the lack of an air cushion in the water pipes or there may be a pipe that is not securely fastened to a wall stud and it rattles when the water is shut off. We suggest that you put a bucket underneath it. Once you have the trap in your hand, carefully dump out its contents and clean it with a small wire brush. Unscrew the nuts by hand and slide them away from the connections. Loosen the slip nuts on the trap with water pump pliers. The trap is the curved pipe under your sink. turn the awitch on and see if the clog is cleared, if not you will have to clear the trap. seat it firml over the opening and firmly push up and down a few times. No socket set, then take a broom handle and stick it in the disposal on an angle against an impeller blade and work the blade back and forth until the jam dislodges.

There will be a hex nut on the shaft inside the disposal.

#HOW TO REMOVE A GARBAGE DISPOSAL AND REPLACE WITH PIPES FREE#

Another way to free up the disposal is by working from above with a socket on the end of a long extension. If you can't find the service wrench in your sink cabinet, you can buy one at any hardware store. As you move the wrench, you are moving the shaft of the disposal. Work the wrench back and forth until the unit moves freely for several revolutions. At the end of this tool is a hex wrench that fits into a hole you'll find on the bottom of the disposal, in the center. It may be taped on the side or in a small plastic pouch stapled to the side of the cabinet. You have a jam in the disposal that needs to be cleared.Ĭheck under the sink for a small L-shaped service wrench that looks like an Allen wrench with a bend on each end. If the unit now hums but will not run, turn it off immediately. Push this button in to reset the thermal overload/reset. If the unit is no longer humming, it probably means the overload has been tripped. Then look under the sink and locate a small red button on the base of the unit. Hot water and a little white vinegar will help clear drain grease and rid the disposal of foul odors.įirst, turn the unit off at the wall switch. Never pour a chemical drain cleaner into a Disposal. If dismantling the Disposal or working on electrical connections, shut off power at the main disconnect. Problems usually involve jams or clogs, or occasionally leaks. There are two types of garbage Disposals, they are the Batch Feed - Activated by turning a stopper and the Continuous Feed - Activated by a wall switch. The resulting pulp is then flushed down the waste line. The disposal's motor powers a flywheel that throws garbage against a shredder. In order to attempt to fix your garbage disposal, it first helps to understand how it works.

How to remove a garbage disposal and replace with pipes